How to make a bird seed feeder using recyclable plastic drinks bottle
This bird feeder is simple to make, you need a drinks bottle , some plastic tubing approximately 15 to 20 mm. Cut out two holes either side of the bottle to the size of your plastic tubing, cut two small pieces of plastic tubing approximately 10mm in length then stick them into the holes, if you made the holes slightly too big you could use some hot melt glue to hold them in. Make two small holes at the base of the bottle to slide in a piece of garden cane so the birds have a perch.
1, Cut out two holes either side of the bottle to the size of your plastic tubing
2, Cut two small pieces of plastic tubing, approximately 10mm in length then stick them in the holes.
Make two small holes at the base of the bottle to slide a piece of garden cane so the birds have a perch.
